The Steam Engine Model opens up a reciprocating steam engine for the classroom: its metal cylinder is cut through and covered with a clear plate, so the piston and slide valve can be watched as they move. The link motion and reversing method also work, and the wheel turns so lightly that blowing air on it starts the model.
| Parameter | Detail |
|---|---|
| Type | Cutaway classroom model of a working steam engine |
| Cylinder | Metal, cross-section cut, covered with a clear plate to show the piston |
| Moving parts | Piston and slide valve both move; link motion and reversing method operate |
| Wheel | Light enough to demonstrate even by blowing air |
| Finish | Parts and cross-sections painted in different colours; many parts chromium-plated and galvanized |
| Dimensions | Approx. 450 × 350 × 300 mm |
| Weight | Approx. 9 kg |
| Product code | SLE/MCE/65 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Following the steam path. Turn the wheel slowly by hand and stop it near each end of the piston stroke. At every stop, students mark on a sketch which port the slide valve has opened to steam and which to exhaust. They then show how the connecting rod turns the back-and-forth motion into rotation of the wheel.
Forward and reverse. Set the link motion to one end of its travel and turn the wheel slowly by hand to a chosen piston position. Note where the slide valve sits. Move the link motion to its other end and look at the valve again. Students explain why steam admitted now would drive the wheel the other way.
Comparing heat engines. Set the model beside the Stirling engine and the Hero engine. In each real machine the fuel burns outside the engine, yet each turns heat into motion differently: steam on a valve-timed piston, a sealed gas heated and cooled in turn, and a reaction jet. A four stroke petrol engine cut section then shows internal combustion for contrast.
From model to plant. After the model lesson, the thermal power plant with steam engine trainer takes the same principle into a full power-plant trainer, and the Marcet boiler lets students relate the pressure of saturated steam to its temperature.
The slide valve moves to and fro over the ports of the cylinder. In one position it opens one end of the cylinder to steam while the other end is open to exhaust. Half a turn later the roles swap, so steam pushes the piston first one way and then back.
The timing of the valve against the crank decides it. The valve drive is set a little more than a quarter turn ahead of the crank in the running direction, so steam always reaches the side of the piston that keeps the wheel going that way. Change that setting and the engine runs backwards.
Moving the link shifts the valve timing so that steam enters on the opposite side of the piston, and the wheel turns the other way. In mid-gear the valve travel shrinks until the ports barely open, so the engine will not pull. Positions part way between, called linking up, cut off the steam earlier in the stroke.
They are the four valve events in each stroke. Admission is when steam starts to enter the cylinder. At cut-off the valve closes and the trapped steam keeps expanding. Release is when the exhaust opens near the end of the stroke. Compression starts when the exhaust closes and the steam left behind is squeezed, cushioning the piston.
Lap is how far the valve overlaps the edge of a steam port when it sits in the middle of its travel; it makes the valve close early so that steam can expand. Lead is how far the port is already open when the piston is at dead centre, so fresh steam meets the piston as the stroke begins.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 14 November 2026