The Mass, Cast Alloy, Hanger pack contains three 50g hangers cast in alloy, each with a stated accuracy of 1%. The hangers carry flat slotted masses that have a large central hole and a small slot, so a class can hang loads at three points at once or replace hangers lost from older sets.
| Parameter | Detail |
|---|---|
| Item | Mass hanger, 50g each |
| Pack size | 3 hangers |
| Material | Cast alloy |
| Accuracy | 1% |
| Compatible masses | Flat masses with a large central hole and a small slot that stops them sliding off |
| Product code | SLE/LB/35 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Parallelogram of forces. Pin a sheet of paper to the board of the law of parallelogram apparatus and run a thread over its pulleys, with a hanger at each end and the third hanger tied to the middle. Load all three, let the knot settle, and mark the thread lines. Two loads drawn to scale as sides of a parallelogram should give a diagonal equal and opposite to the third.
Holding a trolley on a slope. Raise one end of a smooth board, rest a dynamics trolley on it and run a cord, parallel to the board, from the trolley over a bench pulley clamped at the top to one hanger. Add flat masses until the trolley stays at rest. Repeat at steeper angles and compare the hanging load with the trolley's weight times the sine of the angle.
Three springs side by side. Hang three different springs from a set of springs on the rod of a retort stand, one hanger on each, and note every pointer. Add the same flat mass to each hanger in turn, measure the extensions and plot all three lines on one graph to rank the springs by stiffness.
They fit if they are flat masses with a large central hole and a small slot, the design these hangers are made for. Check that the slot passes over the stem and the hole drops onto it. Small masses from a lighter set may have a different hole, so try one before a class uses them.
Each hanger may differ from 50g by up to 1% of that value. That is small beside pulley friction and marking errors in a school force practical, but it adds up when several hangers and masses share one load.
If a hanger rubs on the board or the bench, that contact takes part of its weight and the thread no longer carries the full load. The knot then settles in the wrong place and the parallelogram will not close.
Friction lets the knot rest anywhere within a small range instead of at one point, so the marked angles vary. Keep the pulleys clean and lightly oiled, tap the board gently before marking the threads, and repeat with different loads to see how large the spread is.
No single load may equal or exceed the other two added together, or the knot runs into a pulley and never settles. Loads that leave clear angles between the threads give a larger parallelogram, which is easier to draw and measure accurately.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 15 November 2026