Polythene Wash Bottles are squeeze bottles with flexible walls, an oval section, a screw cap and a bent delivery tube. Pressing the body sends a thin, aimed stream of distilled water or rinsing liquid onto glassware, filter papers or electrodes. One hand works the bottle while the other holds the vessel being rinsed.
| Parameter | Detail |
|---|---|
| Product type | Squeeze-type laboratory wash bottle |
| Material | Polythene, flexible wall |
| Body shape | Oval section |
| Fittings | Screw cap with bent delivery tube |
| Operation | Liquid is expelled by compressing the bottle; one-hand use |
| Product code | SLE/P/12 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Making up a standard solution. Tip the weighed solid through a polythene funnel into a volumetric flask. Rinse the weighing bottle and the funnel walls several times with short jets of distilled water so every trace enters the flask. Swirl until the solid dissolves, fill to just below the mark, then add the last drops slowly.
Washing a precipitate. Pour the mixture onto a folded filter paper, then direct a fine stream around the inside of the beaker to carry the remaining solid into the funnel. Wash the precipitate on the paper with several small portions rather than one large one.
Titration end point. As the end point nears, rinse the inner walls of the conical flask with a little distilled water. Drops of titrant or sample left on the glass then join the reaction, and the added water does not change the amount of reagent present.
Electrode rinsing. Between samples, rinse the bulb of a pH meter electrode with distilled water over a waste beaker and blot it gently. This stops one solution carrying over into the next reading.
Volatile solvents evaporate into the air space above the liquid and raise its pressure, and warmth from your hand raises it further. That extra pressure pushes liquid up the tube even when you are not squeezing. Hold solvent bottles by the neck, keep them away from heat, and loosen the cap briefly to release the pressure.
Give each bottle one liquid for its whole life and mark the contents clearly on the body, with the main hazard for solvents. Many labs also use cap colours to tell distilled water from ethanol or acetone at a glance. Never refill a bottle with a different liquid.
The bend points the stream down and forward, so it can be aimed exactly where it is needed: the inside wall of a beaker, the edge of a filter paper or an electrode bulb. A gentle squeeze then gives a fine, controlled jet rather than a splash.
No. Liquid that has been in a beaker may carry dust or traces of the sample, and pouring it back contaminates the whole bottle. Refill only from a clean stock container, and empty and rinse the bottle from time to time so the water stays clean.
Polythene stands up well to water, dilute acids and alkalis, and alcohols such as ethanol. Chlorinated and aromatic solvents can soften it or pass slowly through the wall, and strong oxidisers attack it over time. Check compatibility before filling a bottle with anything other than water or alcohol.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 14 November 2026